Reading Roof & Leak Pros Reading Roof & Leak Pros

Roof Repair

Chimney Flashing Repair in Reading, PA

Targeted chimney flashing repair to eliminate roof leaks in older Berks County homes.

  • ✓Based in Reading, PA
  • ✓Berks County Coverage
  • ✓Workmanship You Can Inspect

Chimney flashing fails most often where the masonry meets the roof deck on pre-1960 homes common in West Reading and Hyde Park. Temperature swings between hot humid summers and freezing winters loosen step flashing and counter flashing, allowing water to track under shingles and into attics. We use lead or copper step flashing cut to the existing brick courses rather than pre-formed aluminum that cracks against irregular Berks County masonry.

Edge cases include chimneys that lean slightly from age or have been parged multiple times; these require custom cricket fabrication so water sheds away from the high side. In Glenside and near the Berks County Courthouse, slate roofs demand careful removal of individual slates without cracking them during flashing replacement. We never rely on sealant alone because summer UV and winter ice quickly degrade caulk on south-facing slopes.

Code considerations in Reading require flashing to extend at least six inches up the chimney and four inches under the shingles. When we find rotted sheathing from long-term leaks, we replace it before installing new flashing so the repair lasts through the next freeze-thaw cycle. Homeowners near FirstEnergy Stadium often call after heavy summer storms expose flashing that had been leaking slowly all winter.

Technician insight

In Reading, the thing that catches most people out with Chimney Flashing Repair is how the freeze-thaw cycles in Berks County loosen mortar on pre-war brick chimneys around West Reading and Mount Penn, so simply slapping new metal over old joints never lasts.

Hyde Park Chimney Leak After Summer Storms

Water stains appeared on a second-floor ceiling after heavy rain. We found step flashing that had pulled away from the chimney on a 1940s home. The old aluminum had cracked at the bends. We replaced it with copper step flashing woven into the shingles and repointed the counter flashing line. The homeowner reported no further leaks through the next winter.

Chimney Flashing Repair Services We Offer

✓Step Flashing Replacement

Remove failed step flashing and install new lead or copper pieces woven into existing shingles to restore a watertight seal on masonry chimneys.

✓Counter Flashing Repair

Cut new counter flashing into chimney mortar joints and secure it over step flashing to prevent water entry on older brick chimneys in Mount Penn.

✓Cricket Installation

Build a custom saddle behind the chimney to divert water on wide or offset chimneys common in Downtown Reading row homes.

✓Chimney Crown Sealing

Apply compatible masonry sealer and repair cracks in the crown so water cannot run down the flue and damage flashing from above.

✓Slate Roof Flashing Integration

Carefully lift and reset slate around the chimney while installing new flashing without breaking historic slate found on homes near the Pagoda.

Chimney Flashing Repair Cost in Reading, PA

Service Typical Range What Affects It
Standard step flashing replacement $450–$850 Single-story asphalt shingle roof, typical access
Counter flashing and crown tie-in $300–$600 Additional work when mortar joints need cutting
Cricket fabrication and install $650–$1,100 Required on wide chimneys or low-slope sections
Slate roof integration $750–$1,400 Extra time for careful slate handling on older homes

Ranges are typical for Reading, PA and confirmed with an exact written quote before any work starts.

How it works

  1. 1

    On-Site Inspection

    We climb the roof and examine flashing condition, mortar joints, and any signs of interior staining from leaks reported in neighborhoods like Hyde Park.

  2. 2

    Material Removal

    Old flashing and damaged shingles are taken off, with slate handled individually to avoid breakage on older Berks County roofs.

  3. 3

    New Flashing Fabrication

    We cut and bend lead or copper to match the chimney profile and existing shingle courses for a precise fit.

  4. 4

    Installation and Testing

    New flashing is installed, sealed at joints, and the area is watered to confirm no leaks remain before cleanup.

Pricing

Most chimney flashing repairs in Reading fall between a few hundred and low thousands depending on access and materials.

Reading Roof & Leak Pros — roof repair in Reading

Good to know

Chimney Flashing Repair — FAQs

Still have questions? We're happy to talk it through.

(610) 735-6567
+ How do I know if my chimney flashing is leaking?
Look for water stains on ceilings near the chimney, especially after summer storms or spring thaw in Berks County homes.
+ Can you repair flashing without replacing the whole chimney?
Yes, we routinely replace just the flashing and any damaged roofing materials on chimneys throughout Reading and nearby Lancaster.
+ Will new flashing match my slate roof?
We fabricate custom pieces and reset original slate so the repair blends with historic roofs common near the Pagoda and Downtown Reading.
+ How long does chimney flashing repair take?
Most jobs in single-story homes are completed in one day; two-story or slate roofs may require an extra day for access and careful material handling.

Need Roof Leak Repair in Reading, PA?

Talk to a local roof leak repair company serving Reading and nearby neighborhoods.

Call now Get a quote